KYOSHO

INFERNO NEO ST RACE SPEC (RTR)

---

• Syncro - A Stylish FHSS 2.4GHz RC system featuring dual rate function all pre-installed in the NEO. Also features a 4 channel receiver, providing a wide range of upgrades.
• NEO - Based on the Inferno NEO with a racing specification chassis to match the power of the new engine.
• Tuned Muffler - A rear exhaust tuned muffler with hard polish finish and spring connected manifold are included as standard equipment. Giving you the best performance from the .25 KE engine you can get.
• High Torque - Equipped with a high torque metal gear KS-102BK servo for the best performance right out of the box.
• New Threaded Big-Bore Shocks - Features heavy duty big bore oil shocks as standard. Takes even the harshest punishment for long periods without complaint and provides excellent damping power. Strong 3.5mm Big Bore Shocks deliver smooth and effective damping for sure-footed performance on a wide range of surfaces.
• New 12 Spoke Wheel Pattern - The new Inferno NEO Race Spec St comes equipped with Kyosho's brand new 12 spoke wheel design.
• New Kyosho Tires - New block pattern tires are pre-mounted giving you full traction on a wide range of surfaces.
• Flexibility & Rigidity - Composite torque rods on front and rear deliver optimal flexibility and rigidity along the chassis and increase the effectiveness of the suspension for greater traction and consistent handling.
• Hard Anodized - The main chassis, upper and front upper chassis plates and the engine head are anodized in black for added strength and surface hardness giving all your components a longer lifespan.
• Blue 17mm Hubs - New Anodized Blue17mm wheel hubs. Now you can use all standard 17 mm wheels.
• Endless Adjustments - The suspension and steering linkages feature turnbuckles, which allows for quick adjustments to the camber and steering toe angles. All that's needed is a 5.5mm wrench to make any adjustment on the spot - there's no need to detach or move anything to facilitate an adjustment
• Full Ball Bearings - Full ball bearings throughout for maximum efficiency through the drive system.
• Tough Truggy - Factory-assembled chassis shares the same tough characteristics and low center of gravity as the World Championship winning Inferno 7.5
• 4WD - Shaft-driven 4WD chassis with three differentials.
• Clutch System - New 3-piece clutch realizes efficient power transfer and full adjustability by changing your springs (spring rate) you can control all aspects of your clutch.
• Universal Swing Shafts - Equipped with Front Universal Swing Shafts for more of an efficient drive train.
•  150cc. Fuel Tank - 150cc fuel tank delivers long run times for even more dirt action

Special Features

• Factory assembled chassis with pre-adjusted linkages
• Special manifold and muffler
• Pre-painted with stickers pre-attached on completed body
• Pre-Installed Perfex KT-201/4-ch 2-servo (KS-102BK servo spec.)
• Pre-installed KE.25 engine with recoil starter  
• Cross Wrench
• Hex Wrench

Technical Data:

• Length: 550mm (21.6in)
• Width: 427mm (16.8in)
• Height: 225mm (8.8in)
• Wheelbase: 355mm (13.9in)
• Gear Ratio: 13.76:1
• Weight 3,750g
• Engine: Nitro KE.25 (w/ pull start)

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: